mutable c_ignbrk : bool; | Ignore the break condition. |
mutable c_brkint : bool; | Signal interrupt on break condition. |
mutable c_ignpar : bool; | Ignore characters with parity errors. |
mutable c_parmrk : bool; | Mark parity errors. |
mutable c_inpck : bool; | Enable parity check on input. |
mutable c_istrip : bool; | Strip 8th bit on input characters. |
mutable c_inlcr : bool; | Map NL to CR on input. |
mutable c_igncr : bool; | Ignore CR on input. |
mutable c_icrnl : bool; | Map CR to NL on input. |
mutable c_ixon : bool; | Recognize XON/XOFF characters on input. |
mutable c_ixoff : bool; | Emit XON/XOFF chars to control input flow. |
mutable c_opost : bool; | Enable output processing. |
mutable c_obaud : int; | Output baud rate (0 means close connection). |
mutable c_ibaud : int; | Input baud rate. |
mutable c_csize : int; | Number of bits per character (5-8). |
mutable c_cstopb : int; | Number of stop bits (1-2). |
mutable c_cread : bool; | Reception is enabled. |
mutable c_parenb : bool; | Enable parity generation and detection. |
mutable c_parodd : bool; | Specify odd parity instead of even. |
mutable c_hupcl : bool; | Hang up on last close. |
mutable c_clocal : bool; | Ignore modem status lines. |
mutable c_isig : bool; | Generate signal on INTR, QUIT, SUSP. |
mutable c_icanon : bool; | Enable canonical processing (line buffering and editing) |
mutable c_noflsh : bool; | Disable flush after INTR, QUIT, SUSP. |
mutable c_echo : bool; | Echo input characters. |
mutable c_echoe : bool; | Echo ERASE (to erase previous character). |
mutable c_echok : bool; | Echo KILL (to erase the current line). |
mutable c_echonl : bool; | Echo NL even if c_echo is not set. |
mutable c_vintr : char; | Interrupt character (usually ctrl-C). |
mutable c_vquit : char; | Quit character (usually ctrl-\ ). |
mutable c_verase : char; | Erase character (usually DEL or ctrl-H). |
mutable c_vkill : char; | Kill line character (usually ctrl-U). |
mutable c_veof : char; | End-of-file character (usually ctrl-D). |
mutable c_veol : char; | Alternate end-of-line char. (usually none). |
mutable c_vmin : int; | Minimum number of characters to read before the read request is satisfied. |
mutable c_vtime : int; | Maximum read wait (in 0.1s units). |
mutable c_vstart : char; | Start character (usually ctrl-Q). |
mutable c_vstop : char; | Stop character (usually ctrl-S). |